Support forum

Hello Mauricio,

The easiest way to route a message from one connector to another is to use an Emulator Gateway, but a Scripting Gateway is also a good option.

In the Emulator Gateway settings you have to enable the option 'Loop back successfully sent messages as received messages'. And you also have to set the routing options in the 'Gateways' settings of both connectors so that the right connector receives the loop back message.

In the Scripting Gateway you can use a 'PostReceiveMessage' line in the 'OnMessageToSend' method. But I only recommend using a script if you have some programming experience in C#.

Regards, Henk